Appendix; Selection Of Tip; Servicing And Cleaning Of Airless Hard-Metal Tips; Spray Gun Accessories - WAGNER PS 3.20 Instrucciones De Uso

Appendix

12. Appendix
12.1

Selection of tip

To achieve faultless and rational working, the selection of the tip is of the greatest importance.
In many cases the correct tip can only be determined by means of a spraying test.
Some rules for this:
The spray jet must be even.
If streaks appear in the spray jet the spraying pressure is either too low or the viscosity of the coating material to high.
Remedy: Increase pressure or dilute coating material. Each pump conveys a certain quantity in proportion to the size of the tip:
The following principle is valid:
There is a large range of tips with various spraying angles.
12.2

Servicing and cleaning of Airless hard-metal tips

Standard tips
If a different tip type has been fitted, then clean it according to manufacturer's instructions.
The tip has a bore processed with the greatest precision. Careful handling is necessary to achieve long durability. Do not forget the fact that the
hard-metal insert is brittle! Never throw the tip or handle with sharp metal objects.
The following points must be observed to keep the tip clean and ready for use:
1. Turn the relief valve handle fully counterclockwise (k Circulation).
2. Switch off the gasoline engine.
3. Dismount the tip from the spray gun.
4. Place tip in an appropriate cleaning agent until all coating material residue is dissolved.
5. If there is pressure air, blow out tip.
6. Remove any residue by means of a sharp wooden rod (toothpick).
7. Check the tip with the help of a magnifying glass and, if necessary, repeat points 4 to 6.
12.3

Spray gun accessories

Flat jet adjusting tip
up to 250 bar (25 MPa
Spray width at about 30 cm
Tip
removal of spray object
Bore mm
marking
Pressure 100 bar (10 MPa)
15 0.13 - 0.46
20 0.18 - 0.48
28 0.28 - 0.66
41 0.43 - 0.88
49 0.53 - 1.37
Tip extension
with slewable
knee joint
(without tip)
Length: 100 cm Order no. 0096 015
Order no. 0096 016
Length: 200 cm
Length: 300 cm Order no. 0096 017
large tip = low pressure
small tip = high pressure
5 - 35 cm Paints
5 - 50 cm Paints, fillers
8 - 55 cm Paints, dispersions
10 - 60 cm Rust protection paints
- dispersions
10 - 40 cm Large-area coats
Tip extension
15 cm, F-thread, Order no. 0556 051
30 cm, F-thread, Order no. 0556 052
45 cm, F-thread, Order no. 0556 053
60 cm, F-thread, Order no. 0556 054
GB
Flat jet
Use adjusting tip
Order No.
0999 057
0999 053
0999 054
0999 055
0999 056
18
Contact protection
for the flat jet adjustment tip
Order No. 0097 294
15 cm, G-thread, Order no. 0556 074
30 cm, G-thread, Order no. 0556 075
45 cm, G-thread, Order no. 0556 076
60 cm, G-thread, Order no. 0556 077
ProSpray 3.20