Technical Data; Transportation In Vehicle; Starting Operation; High-Pressure Hose, Spray Gun And Separating Oil - WAGNER PS 3.20 Instrucciones De Uso

Description of unit
3.5

Technical data

Voltage
Max. current consumption
Power Cord
Max. operating pressure
Volume flow at 12 MPa (120 bar) with water
Max tip size
Max. temperature of the coating material
Max viscosity
Weight
Special high-pressure hose
Dimensions (L X W X H)
Vibration
Spray gun does not exceed 2.5m/s
Max sound pressure level
* Place of measuring: 1 m in distance from the unit and 1.6
m above the floor, 12 MPa (120 bar) operating pressure,
reverberant floor.
3.6

Transportation in vehicle

Secure the unit with a suitable fastening.
220~240 VAC, 50/60 Hz
5.3 A
See page 76
207 bar (20.7 MPa)
1.62 l/min
0.021 inch – 0.53 mm
43°C
20.000 MPa·s
13.6 kg
6,35 mm, 15 m - 1/4" - 18 NPSM
441 x 324 x 415 mm
80 dB*
GB
4.

Starting operation

4.1 High-pressure hose, spray gun and
separating oil
1. Screw the pressure gauge (1) to the coating material outlet
(Fig. 2, Item 2).
2. Screw the high-pressure hose (3) to the coating material
outlet on the pressure gauge (Fig. 2, Item 4).
3. Screw the spray gun (5) with the selected tip onto the high-
pressure hose.
4. Tighten the union nuts at the high-pressure hoses firmly so
that coating material does not leak.
1
4
2
3
2
5. Fill the oil cup with EasyGlide (Fig. 3). Do not use too much
EasyGlide, i.e. ensure that no EasyGlide drips into the coating
material container.
EasyGlide prevents increased wear and tear to the
packings.
Attention
6. If equipped, fully depress the pusher stem (Fig. 3, item 1) to
make sure the inlet ball is free.
6
Starting operation
1
ProSpray 3.20
5