Tool Holder, Attachments - Festool PDC 18/4 Li Manual De Instrucciones

Position 1 = low torque
Position 12 = high torque
An acoustic signal sounds when the preset torque is
reached and the machine then switches off. You must
release and press the ON/OFF switch [1-4] again to
start the machine.
Drilling
Mark is aligned with drill symbol
torque.
7.4 Impact drilling

The machine was designed for impact drilling into
tiles, masonry and stone.
Set the selector switch [1-6] to the hammer symbol.
Set the adjusting wheel [1-8] to the drill symbol.
8

Tool holder, attachments

WARNING
Risk of injury

Always disconnect the battery pack before per-
forming any type of work on the machine!
CAUTION
Hot and sharp tools
Risk of injury

Do not use insert tools that are blunt or defec-
tive.

Wear protective gloves.

Prior to initial use: apply multi-purpose grease to
the drill spindle and gearbox neck.
8.1 CENTROTEC tool chuck [6]
Quick change of tools with CENTROTEC shaft
Only clamp CENTROTEC tools in CENTROTEC
tool chucks.
Wear gloves when replacing!
8.2 Chuck [7]
For clamping drill bits and bits with max. shaft diam-
eter of 13 mm.
Clamp tool centrally in the chuck.
8.3 Angle attachment [8]
Drilling and screwdriving at right angle to machine
(partly as an accessory).
8.4
Bits can be inserted directly into the hexagon socket
holder of the drill spindle.
8.5
The depth stop (partly as an accessory) allows the
user to insert screws to a predefined depth. You can
set the dimension by which the screw head protrudes
above or is recessed below the surface of the work-
= maximum
piece.
Depth setting
Sleeve A/B must be removed before a screw can be
unscrewed.
9
Risk of injury

Always secure the workpiece in such a manner
that it cannot move while being machined.
9.1
Press = ON, release = OFF

The speed of the machine depends on how far the
on/off switch is pressed in.
9.2
Magnetic, for storing bits and bit holders.
9.3
The belt clip (right/left) allows the user to attach the
machine briefly to work clothing.
9.4
Always use the additional handle.

Position the additional handle [5-2] on the exten-
sion of the gearbox housing and engage the re-
cesses on the additional handle in the lugs on the
housing.

Turn the handle until secured in position.

Turn the handle to adjust the position in 30° incre-
ments.

The drilling depth can be adjusted using the depth
stop [5-1].
9.5
Acoustic warning signals sound and the machine
switches off in the following operating states:
Tool holder in the drill spindle [9]
Depth stop [10]
Turn the housing [10-1] to set the
desired fastening depth. Each de-
tent position changes the fasten-
ing depth by 0.1 mm.
Working with the machine
WARNING
On/Off switch [1-4]
Bit store [1-3]
Belt clip [1-10]
Attaching the additional handle[5]
Acoustic warning signal
PDC 18/4 Li
GB
15