Service And Maintenance; Eu Declaration Of Conformity - Festool PDC 18/4 Li Manual De Instrucciones

Ocultar thumbs Ver también para PDC 18/4 Li:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 24
PDC 18/4 Li
GB
– Preset torque reached.
– "Block protect", starting torque too high.
– Machine overloaded

10 Service and maintenance

WARNING
Risk of injury, electric shock
Always disconnect the battery pack from the
machine before any maintenance or care work!
All maintenance and repair work which requires
the motor housing to be opened, must only be
carried out by an authorised service workshop.
Customer service and repair only
through manufacturer or service work-
shops: Please find the nearest address
at: www.festool.com/service
EKAT
Use only original Festool spare parts!
4
Order No. at: www.festool.com/service
5
3
2
1
Note the following information:
– Keep the ventilation slits on the machine free and
clean to ensure adequate cooling.
– Keep the contacts on the machine, charger and
battery pack clean.
Information on battery packs
– Store in a cool, dry place at a temperature between
5 °C and 25 °C.
– Protect battery packs from moisture, water and
heat.
– Do not leave flat battery packs in a charger discon-
nected from the mains power supply for longer
than one month. Danger of deep discharge!
– If you intend to store li-ion battery packs for longer
periods without use, you should charge them to 40
% capacity (approx. 15 min charging time).
– To avoid short circuits the battery pack should be
stored in the packaging supplied.
– Significantly shorter operating times after each
charge indicate that the battery pack is worn and
should be replaced with a new one.
16
11 Environment
Do not dispose of the device in house-
hold waste! Recycle devices, accesso-
ries and packaging. Observe applicable
national regulations.
EU only: In accordance with European Directive on
waste electrical and electronic equipment and imple-
mentation in national law, used electric power tools
must be collected separately and handed in for envi-
ronmentally friendly recycling.
Return used or faulty battery packs to your local
specialist retailer, Festool after-sales service or near-
est public waste management facility (observe appli-
cable regulations). Batteries must be discharged on
return. Battery packs will then be recycled.
EU only: In accordance with the European Directive on
batteries and implementation in national law, defec-
tive or used battery packs/batteries must be collected
separately and handed in for environmentally friendly
recycling.
Information on REACh: www.festool.com/reach
12 Transport
The lithium-ion batteries are subject to the require-
ments of the legislation on hazardous goods. A li-ion
battery pack alone falls below the applicable limit val-
ue and certified as per UN manual ST/SG/ AC.10/11/
rev. 3 part III, subsection 38.3. However, dangerous
goods regulations may apply when several battery
packs are transported For shipping by third parties
(e.g. air transport or freight forwarding company)
special requirements with regard to packaging and
labelling must be observed.For the preparation of the
package an expert on hazardous goods must be con-
sulted. Please observe any further national regula-
tions.
Only return the battery pack if the housing is undam-
aged. Tape over the exposed contacts and wrap the
battery pack so that it cannot move inside the packag-
ing.

13 EU Declaration of Conformity

Cordless drill
PDC 18/4
Year of CE mark: 2013
We declare under sole responsibility that this product
complies with all the relevant requirements in the fol-
lowing Directives, standards and normative docu-
ments:
Serial no.
768172

Publicidad

Tabla de contenido
loading

Tabla de contenido