j TALLY lamp
Lit when recording is in progress.
It flashes when an error or warning condition
occurs. The main causes are indicated below. For
other causes, refer to the operation manual for the
connected camcorder.
Flashing (1 time/sec): Remaining media
warning (about 5 minutes)
Flashing (4 times/sec): No remaining media
or an error occurred
k POWER indicator
Lit when power is supplied from the camcorder.
l Memory slot cover open button
Press to open the cover when inserting/removing
an AXS memory card.
m AXS memory card slots A/B
Insertion slots for AXS memory cards. Insert an
AXS memory card all the way into the slot with
the AXS logo mark facing the battery.
The following AXS memory cards can be used in
the unit.
• AXS-A1TS24 (1 TB/2.4 Gbps)
• AXS-A512S24 (512 GB/2.4 Gbps)
• AXS-A256S24 (256 GB/2.4 Gbps)
• AXS-A1TS48 (1 TB/4.8 Gbps)
• AXS-A512S48 (512 GB/4.8 Gbps)
Using with a Camcorder
This section describes connection with the
PMW-F5/F55.
When connecting the unit to the MPC-3610, refer
to the operating instructions for the MPC-3610.
Attaching to a Camcorder
Note
Turn off the camcorder before attaching/removing the
unit.
1
Press the release button on the unit (A)
to pop-up the release lever, then raise
the release lever till it points up (B).
2
Insert the tabs on the unit into the
grooves on the rear surface of the
camcorder (A), and lower the release
lever (B).
Using with a Camcorder
19