Sony AXS-R7 Manual De Instrucciones página 20

Notes
• Attach the unit after raising the release lever.
• Check that the four tabs are securely engaged before
lowering the release lever. If not engaged, the unit may
not be attached properly or may damage the camcorder
or unit.
3
Screw the supplied top plate onto the
unit and camcorder (hex key wrench
size 3/16").
Removing from a Camcorder
1
Remove the top plate from the unit and
camcorder.
2
Press the release button and raise the
release lever, then slide the unit upward
and pull it out towards you.
Note
Always support the unit with your hand when removing.
Inserting an AXS Memory Card
1
Press the memory slot cover open
button on the right side to open the
cover.
20
Using with a Camcorder
2
Insert an AXS memory card into the
card slot with the label facing the
direction shown in the diagram.
Label
3
Close the cover.
Note
Push the cover in until the memory slot cover open
button is securely locked.
Removing an AXS Memory Card
Open the memory slot cover on the unit,
and extract the AXS memory card by hand.
Note
Data integrity is not guaranteed if the power is turned off
or a memory card is removed while it is being accessed.
All data recorded on the card may be destroyed. Always
check that the memory card ACCESS lamp is lit green or
off when you turn off the power or remove a memory
card.