Environment; Eu Declaration Of Conformity - Festool KS 60 E KAPEX Manual De Instrucciones Original


Swivel the router [14-1] out in order to gauge
the interior angle.

Close the locking device.
The dashed mark [14-4] provides the angle bisec-
tion. The angle bisection can be transferred via the
outside edges of the bevel to the position markings
on the rotary base.
Gauging the exterior angle [14B]

Open the locking device [14-2].

Slide the aluminium profiles [14-3] on the rout-
er forwards.

Swivel the router [14-1] out so that the alumin-
ium profiles are at the exterior angle.

Close the locking device.

Slide the aluminium profiles for the two routers
back again.
Transferring the angle [15]

Place the angle bevel perfectly in place on one
of the stop rulers

Release the rotary knob

Hook in the detent lever

Swivel the rotary base
edge of the bevel is congruent with the marking
5
.

To do so, the bevel must be positioned so that it
is parallel to the stop of the compound mitre
saw. At the same time, apply pressure to the
stop ruler by pressing in the recessed grip with
your thumb.

Close the rotary knob
bevel.
The angle is transferred, the sawing process can be
started.
10.2 Saw blades, other accessories
In order to saw different materials quickly and
cleanly, Festool offers saw blades for all applica-
tions that are specially designed for your Festool
machine.
.- press with your thumb.
2
.
3
.
4
, until the outside
6
, remove the angle

11 Environment

Do not dispose of the device in house-
hold waste! Recycle devices, accesso-
ries and packaging. Observe applica-
ble national regulations.
EU only: In accordance with European
Directive on waste electrical and electronic equip-
ment and implementation in national law, used
electric power tools must be collected separately
and handed in for environmentally friendly recy-
cling.
Information on REACh: www.festool.com/reach

12 EU Declaration of Conformity

Sliding compound mitre
saw
KS 60 E
Year of CE mark: 2016
We declare under sole responsibility that this prod-
uct complies with all the relevant requirements in
the following directives, standards and normative
documents:
2006/42/EC, 2014/30/EU, 2011/65/EU, EN 61029-1,
EN 61029-2-9, EN 50981.
Festool GmbH
Wertstr. 20, D-73240 Wendlingen, Germany
Wolfgang Zondler
Head of Research, Development and Technical
Documentation
Wendlingen, 2016-05-11
KS 60 E
GB
Series no.
10006965, 200113
27