CAMPAGNOLO NEUTRON Carbon Hub Manual De Uso página 34

5.2 - REAR WHEEL ON THE FREEWHEEL SIDE
• Before proceeding with assembly, check in the technical specifications on page 3 the type and length of the spoke to be replaced, the recommended value
and the maximum value which must not be exceeded when tightening the spokes.
• Check that there are no residues of sand or any other foreign material inside the rim and, if necessary, remove them with a jet of compressed air.
• Obtain an original Campagnolo ®
• Always prevent the rotation of the spokes when nuts are tightened or loosened. Make sure that no damage is caused to the surface of the spokes.
CAUTION!
Take special care when handling the spokes during assembly to prevent accidentally scratching the rim.
• Remove the sprocket set (Section 2 of the "Owner's Manual - PART 1).
• Slightly open the spoke retainer ring of the freewheel and slide it out
(Fig. 17).
• Using a 5 mm hex wrench, completely unscrew the nut of the spoke to
be replaced, holding the latter steady to prevent rotation, remove it,
remove the plate and then slide the spoke out of the rim (Fig. 18).
replacement spoke.
17 18
5 mm
11