CAMPAGNOLO NEUTRON Carbon Hub Manual De Uso página 35

• Remove the spoke together with the cable end (A - Fig. 19).
WARNING!
If necessary, first lift the spoke overlapping the one to be replaced
and, after assembly of the new spoke, make sure it is returned to
exactly the same position.
• Insert the new spoke in the hole in the rim.
• Fit the plate on the spoke, keeping the concave part facing outwards and
position it in the special groove on the rim; when fitting a spoke on the
LH side of the wheel, the long side of the plate must face leftwards and
vice versa, as illustrated in figure 20.
• Tighten the nut (Fig. 20).
WARNING!
When fitting the wheel, check that the plates remain in position
since an incorrectly positioned plate may cause irreparable dama-
ge to the profile of the rim when tensioning the spokes. This
damage could cause the rim to unexpectedly fail, resulting in an
accident, personal injury or death.
12
19
A
20