Installing Magicspeed; Tools Required - Waeco MagicSpeed MS880 Instrucciones De Montaje

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 118
MagicSpeed MS880
 Decreases the engine speed by 75 %
 The ignition is switched off
I
NOTE
If MagicSpeed ever fails to react to one of these occurrences, you
can always switch off the ignition.
The cruise control also switches off if there are problems with the brake
lights, such as:
 Defective brake lights
 A defective fuse
 A loose connection to the brake light switch
In an emergency (e.g. accelerator sticks), you can use the savior function. It
is activated by pressing the accelerator and the brake pedal at the same time.
It is deactivated when the brake pedal is released. The savior function
switches the accelerator to idle electronically, it does not apply the brake.
Therefore, keep the brake pedal pressed down until the vehicle stops.
To guarantee safe and economical operation, never use the cruise control in
congested traffic or on wet, slippery roads.
7

Installing MagicSpeed

I
NOTE
If you do not have sufficient technical knowledge for installing and
connecting the components in vehicles, you should have a spe-
cialist install the system in your vehicle.
7.1

Tools required

For installation and assembly and the electrical connection, you will need
the following tools fig. 1, page 3.
To fasten the module and the cables, you may need additional screws and
cable binders.
EN
Installing MagicSpeed
53

Publicidad

Tabla de contenido
loading

Tabla de contenido