Installing The Control Element (Accessory) - Waeco MagicSpeed MS880 Instrucciones De Montaje

Installing the control element (accessory)

With this solution, no additional overspeed protection is required because the
engine speed is monitored by the speed regulator. If you use the engine
speed signal, the activation speed of the speed regulator depends on the
gear the vehicle is currently in.
8.2 Connecting the vehicle-specific cable set
You must connect the electronic module to the accelerator pedal using a
vehicle-specific cable set (not supplied).
A
NOTICE! Risk of damage!
Do not connect the green cable of the main wiring harness to the
earth. The earth connection is made via the accelerator cable set.
➤ Cut the the original connection of the accelerator pedal.
➤ Connect one end of the vehicle-specific cable set to the accelerator pedal.
➤ Connect the other end of the vehicle-specific cable set to the loose end of
the original connection.
➤ Insert the 8-pin plug into the appropriate socket on the electronic module.
9 Installing the control element
(accessory)
A number of different control elements (such as MS-BE3 or MS-BE4) are
available for maximum user convenience, depending on your requirements.
➤ Read the instructions enclosed with your control element carefully before
assembly.
62
MagicSpeed MS880
EN