Waeco MagicSpeed MS880 Instrucciones De Montaje página 54

Installing MagicSpeed
7.2 Installing the electronic module
I
NOTE
When selecting the installation location, observe the following
instructions:
 Install the electronic module
– behind the glove compartment
– behind the footwell on the driver or passenger side
– under the dashboard on the driver side
– not anywhere subject to heat or moisture
– not in the engine compartment
– not near high-voltage components
– not directly next to ventilator nozzles.
 Where possible, use existing holes in the vehicle.
A
NOTICE!
Before drilling holes, make sure the drill bit will not damage any-
thing on the other side (fig. 2, page 4).
➤ Select a suitable installation location (fig. 5, page 5).
Do not fasten the electronic module before you have decided where to
lay the cables.
➤ After finishing assembly, fasten the module to the selected position:
screw the electronic module securely to the vehicle with the screws sup-
plied or use double-sided adhesive tape.
54
MagicSpeed MS880
EN