Waeco MagicSpeed MS880 Instrucciones De Montaje página 69

MagicSpeed MS880
➤ Press the setup button four times in rapid succession.
➤ Release the brake.
✓ You will hear four acoustic signals.
✓ You are now in setup mode and can set the cruise control.
12.3 Adjusting the accelerator pedal manually
In this mode, the accelerator pedal parameters are taught to the electronic
module manually.
I
NOTE
 After each programming step is successfully completed, it is
confirmed by an intermittent tone of the same pitch. If there is
an intermittent tone of differing pitch, this step has failed and
the programming must be repeated from step 1.
 Some accelerator pedals do not provide sufficient electric sig-
nals when fully pressed down. In this case, only press the
pedal approx. three-quarters of the way down, as otherwise
programming will not be successful.
Step 1
➤ Start setup mode (chapter "Starting setup mode" on page 68).
➤ Apply the brake and hold it down.
➤ Press the RES button once.
✓ An low-pitched acoustic signal sounds.
➤ Release the brake.
Step 2
➤ In neutral position (accelerator pedal is not pressed down), press the
SET-button once.
✓ The idling value is programmed.
Step 3
➤ Press the accelerator pedal down as far as it will go and press the RES
button once.
EN
Synchronising with an analogue connection
69