Waeco MagicSpeed MS880 Instrucciones De Montaje página 56

Connecting the electrical power to MagicSpeed
You will find a summary of the wiring in fig. 7, page 6.
No. Component
1 Electronic module
2 Control element
3 Ignition coil
4 Engine speed signal
5 Brake light switch
6 Original clutch switch
7 Clutch switch
8 Ignition
9 Travel speed signal
10 Vehicle-specific cable set (not included)
Orange
A
NOTICE!
Make sure the ignition is switched off. Otherwise a fuse may blow.
➤ Connect the orange cable to a connected positive terminal (terminal 15).
➤ Use a voltmeter to check whether the selected positive terminal carries
the full operating voltage of 12 V and that the orange cable carries no
voltage when the ignition is off.
This test is usually done at the fuse box.
A
NOTICE!
Do not connect the orange cable to the voltage supply for the
vehicle accessories (ACC).
Green
➤ Insulate the green cable.
This cable is not needed. The required earth signal is taken from the
accelerator cable set.
56
MagicSpeed MS880
EN