Synchronising With An Analogue Connection - Waeco MagicSpeed MS880 Instrucciones De Montaje

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 118

Synchronising with an analogue connection

12
Synchronising with an analogue
connection
I
NOTE
Before you can configure the settings, you must switch the system
to analogue connection.
12.1
Switching MagicSpeed to analogue connection
➤ Press and hold the SW1 button on the rear of the electronic module.
➤ Switch on the ignition.
✓ You will hear two high-pitched signals.
➤ Let go of the SW1 button.
➤ Press the RES button on the control element.
✓ The electronic module is switched from the "CAN bus connection" setting
to the "Analogue connection" setting.
✓ When the switchover is complete, you will hear four high-pitched signals.
➤ Switch the ignition off.
12.2
Starting setup mode
I
NOTE
 To begin one of the adjusting and teach modes you must
always carry out the following procedure.
 For automatic mode (page 73), you first have to start the
motor.
 For any of the other modes, you first simply have to switch the
ignition off and on again.
To start setup mode, proceed as follows:
➤ Depending on the mode, do one of the following:
– For automatic mode: start the motor.
– For the other modes: switch the ignition off and on again.
➤ Press the ON/OFF button on the control element.
➤ Apply the brake within one minute and hold it down.
68
MagicSpeed MS880
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido