Using MagicSpeed
Accelerating and decelerating
If the cruise control is activated, you have the option of fine tuning it.
This allows you to adapt the speed of the vehicle precisely to suit traffic
conditions or speed limits.
➤ Touch the SET button to increase the speed by 1.5 km/h.
➤ Press the SET button for 1 second to increase the speed by 10 km/h.
➤ Touch the RES button to decrease the speed by 1.5 km/h.
➤ Press the RES button for 1 second to reduce the speed by 10 km/h.
If, for example, you wish to increase the speed by around 5 km/h, touch the
SET button three times.
I
NOTE
If you wish to decrease the set speed sharply, do not use the RES
button.
Use the ON/OFF button, the brake or the clutch and then press
the SET button to set the speed you prefer.
15.2
Resetting the software
➤ Press and hold the SW1 button on the rear of the electronic module.
➤ Switch on the ignition.
✓ You will hear two high-pitched signals.
➤ Let go of the SW1 button.
➤ Press the SET button on the control element.
✓ The LED on the electronic module starts flashing.
✓ The electronics start to synchronise with the vehicle automatically and
reset the software to its status when delivered.
✓ After the software is successfully reset, you will hear three signals.
➤ Switch the ignition off.
78
MagicSpeed MS880
EN