MagicSpeed MS880
Green/white and violet
I
NOTE
With a CAN bus connection, these cables are only connected
when there is no clutch signal on the CAN bus in your vehicle. See
also the information in the vehicle-specific product overview at
www.dometic-waeco.com/MS880.
Alternatively, you can connect the purple cable with:
a clutch switch
the control lamp for the activated parking brake
(automatic transmission only): the control lamp for park or neutral
You can connect the clutch switch supplied or the vehicle's original clutch
switch (if available) to the green/white and purple cable.
Using the clutch switch supplied
➤ Install the clutch switch as described in chapter "Installing the clutch
switch" on page 55.
Using the original clutch switch
➤ Cut off the two-pin plug from the green/white and purple cable.
➤ Connect the purple cable with the original clutch switch cable, whose
signals change when you apply the clutch pedal.
The purple cable can process the following changes:
– Connect to earth
– From earth to ∞
– From earth to +12 V
– From +12 V to earth
➤ Insulate the green/white cable.
This cable is not required when using an original clutch switch.
EN
Connecting the electrical power to MagicSpeed
57