Setting The Time And Date - Microlife 3AA1-1 Instrucciones De Uso

Comment:
If it is not possible to fit the cuff to your left arm,
it can also be placed on your right arm. However,
all measurements should be made using the
same arm.
Cuff on
right arm

5.4. Setting the time and date

This blood pressure monitor incorporates an integrated clock with date display. Time and
date are recorded along with pressure and pulse. After new batteries have been inserted,
the clock begins to run from the following setting: 1999-01-01 00:00 O'clock.
You must then re-enter the date and current time. Please proceed as follows (Example:
Entering 2002-06-15 Time 09:30 AM):
1. Press the User/Time button for at least 3 seconds.
The display now indicates the set year, all characters are blinking.
2. The correct year can be entered by pressing the
MEMORY button. Each click will change the clock 1 year.
3. Press the User/Time button again. The display
now switches to the current date, during which the
first character (month) blinks.
Note: Holding the button down speeds up the procedure.
4. The current month can now be entered by pressing
the MEMORY button. (Example: pressing 5 x
advances 5 months)
5. Press the User/Time button again. The last two
characters (day) are now blinking.
6. The current day can now be entered by pressing
the MEMORY button. (Example: 14 x presses
advances the day from the 1st to 15th)
7. Press the User/Time button again. The display
now switches to the current time, during which the
first character (Hour) blinks.
8. The corresponding hour can now be entered by
pressing the MEMORY button. (Example: 9 x
presses)
10