Searching a track by listening to
track passages - ZAPPINTM
While playing back short track passages in a
USB device in sequence, you can search for a
track you want to listen to.
ZAPPIN mode is suitable for searching for a
track in shuffle or shuffle repeat mode.
Radio
Storing and receiving stations
Caution
When tuning in stations while driving, use Best
Tuning Memory (BTM) to prevent an accident.
~
(BACK)
Select button
•
12
ZAP
1
Press
(ZAP/SHUF)
during playback.
After "ZAPPIN" appears in the display,
playback starts from a passage of the next
track.
The passage is played for the set time, then a
click sounds and the next passage starts.
L-----t------'
The part of each track to
playback in ZAPPIN mode.
2
Press the select button or
(ZAP/SHUF)
when a track you want to listen is
played back.
The track that you select returns to normal
play mode from the beginning.
To search a track by ZAPPIN mode again,
repeat steps 1 and 2.
Tips
• You can select the playback time from about 6
seconds/15 seconds/30 seconds (page 20). You
cannot select the passage of the track to playback.
• Press
+. . ./.......
in ZAPPIN mode to skip
a
track.
• Pressing ~ (BACK) also confirms
a
track to
playback.
Storing automatically - BTM
1
Press
(SOURCE/OFF)
repeatedly until
"TUNER" appears.
To change the band, press
(MODE)
repeatedly. You can select from FM
I,
FM2,
FM3, AM 1 or AM2.
2
Press and hold the select button.
The setup display appears.
3
Press the select button repeatedly
until "BTM" appears.
4
Press+~.
The unit stores stations in order of frequency
in the preset list.
A beep sounds when the setting is stored.
Storing manually
1
While receiving the station that you
want to store, press
Q
(BROWSE).
The preset list appears.
2
Rotate the control dial to select the
preset number.
3
Press and hold the select button until
"MEMORY" appears.
(with the card remote commander)
1
While receiving the station that you
want to store, press and hold a
number button (CD to CD) until
"MEMORY" appears.
Note
If you try to store another station on the same number
button, the previously stored station will be replaced.