The Auto Off function does not operate.
The unit is turned on. The Auto Off function activates
after turning off the unit.
- Tum off the unit.
DSO does not function.
• Depending on the type of car interior or type of
music, DSO may not have a desirable effect.
Radio
recept~on
The stations cannot be received.
The sound is hampered by noises.
• The connection is not correct.
-Connect a power antenna (aerial) control lead
(blue) or accessory power supply lead (red) to the
power supply lead of a car's antenna (aerial)
booster (only when your car has built-in FM/AM
antenna (aerial) in the rear/side glass).
- Check the connection of the car antenna (aerial).
- If the auto antenna (aerial) will not go up, check
the connection of the power antenna (aerial)
control lead.
-
When the DSO mode is on, the sound is
sometimes hampered by noises.
Set the DSO mode to "OFF" (page 19).
Preset tuning is not possible.
• Store the correct frequency in the memory.
• The broadcast signal is too weak.
Automatic tuning is not possible.
• Setting of the local seek mode is not correct.
- Tuning stops too frequently:
Set "LOCAL-ON" (page 20).
- Tuning does not stop at a station:
Set "LOCAL-OFF" (page 20).
• The broadcast signal is too weak.
-
Perform manual tuning.
During FM reception, the
"ST"
indication
flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
-
Set "MONO-ON" (page 20).
An FM program broadcast in stereo is heard in
monaural.
The unit is in monaural reception mode.
-Set "MONO-OFF" (page 20).
RDS
PTY displays "- - - - - - - -."
• The current station is not an RDS station.
• RDS data has not been received.
• The station does not specify the program type.
USB playback
You cannot play back items via a USB hub.
This unit cannot recognize USB devices via a USB
hub.
Cannot play back items.
A USB device does not work.
-
Reconnect it.
The USB device takes longer to play back.
The USB device contains files with a complicated tree
structure.
The display items do not scroll.
• A large number of characters may not scroll.
• "A.SCRL" is set to "OFF."
- Set "A.SCRL-ON" (page 20).
- Press and hold
(DSPL)
(SCRL).
A beep sounds.
During playback, the USB device has been
disconnected.
- Before disconnecting a USB device, make sure to
stop playback first for data protection.
The sound is intermittent.
The sound may be intermittent at a high-bit-rate of
more than 320 kbps.
Error displays/Messages
CHECKING
The unit is confirming the connection of a USB device.
- Wait until confirming the connection is finished.
DEVICE INSIDE
If you turn the ignition switch to the OFF position
without removing the USB device or iPod, "DEVICE
INSIDE" will appear in the display.
ERROR
USB device was not automatically recognized.
•
- Reconnect it again.
FAILURE (Illuminates until any button is pressed.)
The connection of speakers/amplifiers is incorrect.
- See the installation/connections manual of this
model to check the connection.
FAILURE (Illuminates for about I second.)
When the SAT tuner is connected, storing an SAT
radio channel into a preset failed.
- Be sure to receive the channel that you want to
store, then try it again.
HUB NO SUPRT (HUB Not Support)
USB hub is not supported on this unit.
L. SEEK
+/-
The local seek mode is on during automatic tuning.
NO DEV (No Device)
USB is selected as source without a USB device
connected. A USB device or a USB cable has been
disconnected during playback.
- Be sure to connect a USB device and USB cable.
NO MUSIC
The USB device does not contain a music file.
- Connect a USB device with a music file in it.
NO NAME
A album/artist/track name is not written in the track.
continue to next page-+
25