Removing The Unit; Specifications - Sony DSX-S100 Manual De Instrucciones

Removing the unit
1
Remove the protection collar.
o
Detach the front panel (page 7).
e
Pinch both edges of the protection collar,
then pull it out.
2
Remove the unit.
o
Insert both release keys simultaneously
until they click.
Hook facing
inwards.
S
Pull the release keys to unseat the unit.
e
Slide the unit out of the mounting.
Specilications
FOR UNITED STATES CUSTOMERS. NOT
APPLICABLE IN CANADA, INCLUDING
IN THE PROVINCE OF QUEBEC.
POUR LES CONSOMMATEURS AUX
ETATS-UNIS. NON APPLICABLE AU
CANADA, Y COMPRIS LA PROVINCE DE
QUEBEC.
AUDIO POWER SPECIFICATIONS
CEA2006 Standard
Power Output: 17 Watts RMS x 4 at
4 Ohms < 1
%
THD+N
SN Ratio: 80 dBA
(reference: 1 Watt into 4 Ohms)
Tuner section
FM
TIming range: 87.5 - 107.9 MHz
Antenna (aerial) terminal:
External antenna (aerial) connector
Intermediate frequency: 150 kHz
Usable sensitivity: 10 dBf
Selectivity: 75 dB at 400 kHz
Signal-to-noise ratio: 70 dB (mono)
Separation: 40 dB at 1 kHz
Frequency response: 20 - 15,000 Hz
AM
Thning range: 530 - 1,710 kHz
Antenna (aerial) terminal:
External antenna (aerial) connector
Intermediate frequency: 25 kHz
Sensitivity: 26 11 V
USB Player section
Interface: USB (Full-speed)
Maximum current: 500 rnA
Power amplifier section
Output: Speaker outputs
Speaker impedance: 4 - 8 ohms
Maximum power output: 52 W x 4 (at 4 ohms)
General
Outputs:
Audio outputs terminal (front, sub/rear switchable)
Power antenna (aerial) relay control terminal
Power amplifier control terminal
Inputs:
BUS control input terminal
BUS audio input terminal
Remote controller input terminal
Antenna (aerial) input terminal
Telephone ATT control terminal
Illumination control terminal
AUX input jack (stereo mini jack)
USB signal input connector
•
continue to next page
--+
23