Getting Started
Resett~ng
the
unit
Before operating the unit for the first time, or
after replacing the car battery or changing the
connections, you must reset the unit.
Detach the front panel (page 7) and press the
RESET button (page 8) with a pointed object,
such as a ball-point pen.
Note
Pressing the RESET button will erase the clock setting
and some stored contents.
Canceling the DEMO mode
You can cancel the demonstration display which
appears during turning off.
1
Press and hold the select button.
The setup display appears.
2
Press the select button repeatedly
until "DEMO" appears.
3
Rotate the control dial to select
"DEMO-OFF."
4
Press and hold the select button.
•
The setup is complete and the display returns
to normal reception/play mode.
Preparing the card remote
commander
Remove the insulation film.
Tip
For how to replace the battery, see page 22.
Setting the clock
The clock uses a 12-hour digital indication.
1
Press and hold the select button.
The setup display appears.
2
Press the select button repeatedly
until "CLOCK-ADJ" appears.
3
Press+~.
The hour indication flashes.
6
4
Rotate the control dial to set the hour
and minute.
To move the digital indication, press
-~
/
+~.
5
After setting the minute, press the
select button.
The setup is complete and the clock starts.
To display the clock, press
(DSPL).
Press
( DSPL)
again to return to the previous display.
Tip
You can set the clock automatically with the RDS
feature (page 14).