Problem Causes And Solutions - Topcom BABYTALKER 3100 Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 41
Do not use cleaning products or solvents. They can damage the case or seep into the equipment and
cause permanent damage.
10.2 Cleaning
– Clean the equipment with a soft, slightly dampened cloth.
– Clean soiled connectors and contacts with a soft brush.
– Clean the battery contacts and battery compartment with a dry, lint-free cloth.
– If the equipment gets wet, switch it off and remove the batteries immediately.
Wipe the battery compartment dry with a soft cloth in order to minimise potential water damage.
Leave the battery compartment open until it is completely dry.
Do not use the equipment before it is completely dry.
10.3 Maintenance
– Check the batteries (regular or rechargeable) in the equipment regularly and replace them when necessary.
– Check the connectors and cables for defects.
CAUTION
If you suspect that the equipment is damaged, always have it checked by an expert before using it
again.
11
Troubleshooting
This section provides important instructions for localising and correcting problems.
Follow these instructions in order to avoid hazards and damage.
11.1 Safety Instructions
DANGER
Risk of fatal injury due to electric shock!
Unplug the power cable before attempting to correct a problem.
CAUTION
Risk of hazard due to incorrect repairs
Incorrect repairs can expose users to serious hazards and cause damage to the equipment.
Never attempt to modify or repair the equipment.
Always have repairs to equipment or cables performed by a specialist or the service centre.
If you suspect that the equipment is damaged (for example, if it has fallen on the floor), have it
checked by a specialist before you use it again.

11.2 Problem Causes and Solutions

The following table is intended to help you localise and solve minor problems.
Problem
The rechargeable
battery pack of the
parent unit does not
charge
Parent unit does not
switch on
8
Possible cause
Charging station plug not connected
Dirty contacts
The rechargeable battery pack is
defective
The rechargeable battery pack is not
charged
Equipment defective
Babytalker 3500 SEDS
Solution
Connect plug
Clean the battery terminals and
charging station contacts with a soft
cloth
Replace the battery pack
Charge the battery pack
Contact customer service

Publicidad

Tabla de contenido
loading

Tabla de contenido