Connecting The Baby Unit To The Ac Mains; Operation And Use; Switching The Baby Unit And Parent Unit On And Off - Topcom BABYTALKER 3100 Manual De Usuario

8.3

Connecting the Baby Unit to the AC Mains

Insert the small plug of the AC mains adapter in the mains power
connector of the baby unit
connector (230 V / 50 Hz).
CAUTION
• The mains connector must be within easy reach so you can
quickly unplug the power cable in an emergency.
• Use only the supplied AC mains adapter (6 V DC / 300 mA).
8.4 Installing Rechargeable Batteries in the Parent Unit
See Figure B on the fold-out page.
CAUTION
• Use only the supplied NiMH battery pack in the parent unit.
– Rotate the belt clip
– Turn the screw on the cover of the battery compartment at the back of
the parent unit 90° counterclockwise and remove the battery
compartment cover.
• Do not turn the screw past the 'Open' point.
– Place the NiMH battery pack in the battery compartment.
Ensure that the tab of the battery pack fits in the corresponding recess
and that the polarity matches the figure (B).
– Carefully close the battery compartment and rotate the belt clip back
downward.
8.5 Installing the Parent Unit charging cradle
– Insert the small plug of the AC mains adapter in the mains power connector
plug the AC mains adapter into a mains connector (230 V / 50 Hz).
– Place the parent unit in the charging station. The red Charging LED
• It takes around 10 hours to fully charge the batteries.
9

Operation and Use

9.1

Switching the Baby Unit and Parent Unit On and Off

– Press the On/Off switch
– Press the On/Off switch
• The parent unit will try to establish a connection with the baby unit. If the Link LED
on, a connection has been established. If it does not, see below.
– Press the On/Off switch
– Press the On/Off switch
9.2 Checking the Link Between the Parent Unit and the Baby Unit
You should always check the wireless link when you use the babyphone for the first time.
– Put the parent unit in the same room as the baby unit, separated by at least two metres.
– Switch on both devices. The parent unit will try to establish a connection with the baby unit.
– The green Link LED
If NEMo mode is turned OFF (see "9.4 NEMo Switch Setting"): The LED
after a connection has been established.
If NEMo mode is turned ON: The green link LED
Once the link is established, the LED
capture any sound, the LED
6
8 and plug the AC mains adapter into a mains
upward.
18
to switch on the parent unit. The power LED
15
to switch on the baby unit. The power LED
4
to switch on the parent unit. The power LED
15
to switch off the baby unit. The power LED
4
13 on the parent unit blinks while it is trying to establish a connection.
13
will light continuously. After a while, when the baby unit doesn't
13 will flash every 5 seconds because the baby unit stops the transmission.
Babytalker 3500 SEDS
SEDS
LONG
ECO
20
will go on.
13
on Parent Units will flash until they communicate.
6V/300mA
B A
+
of the charging station and
21
will lit.
17
will lit.
2
goes
13
will go out.
17
will go out.
2
13
stays on continuously
OPEN