Tube Preparation; Assembling The Tubular S Module - Tube; Fitting The Oximo Io Module With The Tube Equipped With The Tubular S Module; Wiring - SOMFY Oximo 50 S Auto io Guia De Instalacion

Oximo 50 S Auto io

4.3. Tube preparation

1) Cut the roller tube to the required length.
2) Deburr the roller tube and remove the swarf.
3) For smooth roller tubes (I), cut a notch with the following
measurements:
- e = 4 mm; l = 28 mm

4.4. Assembling the Tubular S Module - tube

This procedure is not valid for the short accessories - drive wheel and end piece - specific to
low-width aprons.
1) Slide the Tubular
into the roller tube.
For smooth roller tubes, position the notch previously cut
on the crown.
2) For safety reasons, fix the roller tube to the drive wheel
with 4 x Ø 5 mm self-tapping screws or 4 steel pop rivets
of Ø 4.8 mm located:
- at least 5 mm from the far end of the drive wheel: L1
- 5, and
- no more than 15 mm from the far end of the drive wheel.
The screws or pop rivets must only be attached to the drive wheel and not to the Tubular S
Module.
4.5. Fitting the Oximo io Module with the tube
equipped with the Tubular S Module
1) Fit the tube complete with Tubular S Module (D) to the
end bracket (J).
2) Insert the connector (K) of the Oximo io Module (E) into
the Tubular S Module (D).
Screw the connector (K) into the Tubular S Module (D).
3) Fit the tube complete with Tubular S Module (D) to the
motor bracket (L).
Depending on the type of bracket, fit the stop
ring (M).
5.

WIRING

Always make a loop in the power supply cable to prevent
water entering the motor!
- Turn off the power supply.
- Connect the motor as per the table below:
230 V ~ 50 Hz
1 Brown Live
2 Blue Neutral
3 Yellow/Green Earth ( )
4
S Module
Motor cable
OFF
1
3
1
(D)
D
2
1
2
D
3
M
L
2
3 x 0.75 mm
230 V
1
~
2
50 Hz
3
2
3 x 1.5 mm
Copyright © 2010 Somfy SAS. All rights reserved.
2
Ø > 47
I
e
I
15 mm
5 mm
L1
20 mm
J
D
E
K
D
1
2
3