Commissioning; Identifying Setting Steps Already Completed; Pre-Programming The Somfy Io Local Control Point - SOMFY Oximo 50 S Auto io Guia De Instalacion

6.

COMMISSIONING

The guide only describes commissioning using a Situo io type Somfy io local control point. For
commissioning using any other io control point, refer to the corresponding guide.

6.1. Identifying setting steps already completed

During the setting stage, only supply power to the
Oximo 50 S Auto io whose settings are to be adjusted.
Switch on the power and follow procedure «a» or «b»,
depending on the roller shutter's reaction:
The roller shutter moves briefly
a
The settings have been confirmed and no io control
point has been programmed.
Programming the first Somfy io local control point:
1) Simultaneously press the Up and Down buttons on
the Somfy io local control point (G) until the roller
shutter moves briefly.
2) Briefly press the PROG button on the Somfy io local
control point (G): the roller shutter will move briefly;
the control point has been programmed.
or
b
The roller shutter does not move
Press the Up or Down button, and follow procedure «b1»
or «b2» depending on the roller shutter's reaction.
b1 The roller shutter still does not move
The settings have not been confirmed and no io
control point has been programmed.
Follow the procedure from the
«Pre-programming the Somfy io local control
point» chapter.
or
b2
The roller
completely
The settings have been confirmed and the
io control point has been programmed.
Go to chapter «Operation».

6.2. Pre-programming the Somfy io local control point

- Press the Up and Down buttons simultaneously: the roller
shutter moves briefly; the Somfy io local control point has
been pre-programmed into the motor.
Copyright © 2010 Somfy SAS. All rights reserved.
is raised or lowered
shutter
Oximo 50 S Auto io
ON
1 2
(G)
PROG
Pre-programming
Programming
the 1st
Somfy io local
control point
b1
or
b2
the Somfy
io local
control point
Operation
5