Connecting The Units; Before Connecting The Amplifier - Pioneer GM-D1004 Manual De Instrucciones

Connecting the units

Connection of power cord
and speaker
CAUTION
Connect the yellow cord to the terminal linked to
the fuse unit of the car.
1
2
3
c
1 Fuse 15 A × 1
2 To power cord input
3 Speaker cord
White: Front left +
White/black: Front left *
Gray: Front right +
Gray/black: Front right *
Green: Rear left +
Green/black: Rear left *
Violet: Rear right +
Violet/black: Rear right *
4 Black (chassis ground)
5 Yellow
Connect to the constant 12 V supply terminal.
6 Blue/white
Connect to system control terminal of the car
stereo.
7 Red
8 Orange/white
9 Yellow/black
a Pink
b ISO connector (Power)
c ISO connector (Speaker)
4
5
6
Note
INPUT SELECT (input select) switch must be set.
For details, see Setting the unit on page 4.
7
8
Before connecting the
9
a
amplifier
b
! Secure the wiring with cable clamps or adhe-
! Never cut the insulation of the power supply
! Never shorten any wires, the protection circuit
! Never wire the speaker negative cable directly
! Never band together multiple speaker's nega-
Connect to terminal controlled by ignition
switch (12 V DC).
Connect to lighting switch terminal.
If you use an equipment with Mute function,
wire this lead to the Audio Mute lead on that
equipment. If not, keep the Audio Mute lead
free of any connections.
Connect to car speed signal input.
Connect to the power supply terminal of the
car stereo.
Connect to the speaker terminal of the car
stereo.
WARNING
sive tape. To protect the wiring, wrap sections
in contact with metal parts in adhesive tape.
to feed power to other equipment. Current ca-
pacity of the wire is limited.
CAUTION
may malfunction.
to ground.
tive cables.
Section
03
5
En