Foppapedretti Eureka Manual De Instrucciones página 21

• ENGLISH •
ASSEMBLY - USE
STORAGE BASKET
(fig.from 16 to 24)
Disassembly: open the rear zip and remove the rear fabric flap on the basket by pulling it off one
end of the metal trim.
Unhook the elastic loops on the fabric in the front of the basket.
Slide the fabric towards the back, pulling off the top edge with strengthened lining, from the
housing along the front trim of the metal ring (fig. 19, 20).
Assembly: Insert the top edge of the basket, with strengthened lining, into its housing along the
front metal trim on both sides. Attach the elastic loops (fig. 21, 22). Insert the rear fabric flap,
with strengthened lining, into its housing along the rear trim, paying attention when it is mounted
that the zip slider attachment side is on the right of the stroller (when observing the stroller in use
mode). Hook and close the zipper (fig. 24).
FITTING THE HOOD
Fitting the hood (fig. 25, 26): fasten the hood support to both sides of the chassis.
Fasten the press fasteners of the hood behind the backrest.
Removing the hood (fig.27): pull and release the hood support from both sides of the chassis.
FITTING THE FOOTMUFF
(fig.28, 29)
Insert the lower part of the footmuff on the seat of the chassis.
Secure the footmuff to the chassis of the pushchair using the press fasteners (fig. 29).
FITTING THE PUSHCHAIR RAINCOVER
(fig.30)
Fit the raincover over the hood.
Fasten the edges at the back of the raincover using the Velcro tabs.
Fasten the front of the raincover to the chassis of the pushchair using the Velcro tabs.
USE
HOW TO OPEN THE PUSHCHAIR
(fig.31, 32, 33, 34)
Move the closing lever "a", as shown in the figure (fig.31a, 31b).
Lift the handlebar until the chassis opens completely. A click will indicate that is has been fastened.
To lower the seat into a horizontal position (fig.34).
WARNING: Before use, pull the seat upwards to check that it has been fastened correctly to the
chassis.
Before using the stroller, make sure it is opened properly and the mechanisms are properly locked
(fig. 35).
PARKING BRAKE
To apply the brake (fig.36): Press the brake lever, push the pushchair forward gently to ensure the
brake has been applied correctly.
To release the brake (fig.37): lift the lever.
TO ADJUST THE HANDLEBAR
(fig. 38, 39, 40)
Release the locking lever on both sides and extend the handlebar to the desired position (fig. 38, 39).
Attach the locking lever on both sides to lock the handlebar in the chosen position (fig. 40).
Make sure that the handlebar is properly locked in the new position.
21