Installing The Car Seat In The Vehicle - Foppapedretti Eureka Manual De Instrucciones

3. INSTALLAZIONE DEL SEGGIOLINO AUTO NEL VEICOLO (fig.10, 11, 12)
To secure the car seat in the vehicle with the 3-point seat belt, proceed as
follows:
Pass the horizontal seat belt (the lap belt) of the car through both belt guides (1)
and fasten the buckle (2).
Pass the diagonal seat belt (the chest belt) of the car around the backrest of the
car seat, passing through the diagonal belt guide (3).
If the vehicle's seat belt is too short, adjust its height to the lowest position.
If it is still too short, try another passenger seat.
WARNING:
• DO NOT route the vehicle belt using any other path when using the child seat.
For assistant contact our Customer Service team.
• DO NOT use 2 point vehicle belt to install this child seat.
• ONLY install the child restraint rear-facing on forward-facing vehicle seats.
• Make sure the child is properly secured in the child restraint, and the child
restraint is tightly installed in the vehicle.
Check that the car seat has been installed correctly in the vehicle
To ensure the safety of your child, check that ...
• the car seat is installed so that the child is facing in the opposite direction to
the direction of travel,
• the car seat is installed on the front passenger seat only if there is no AIRBAG
or if this has been disabled,
• the car seat is secured with a 3-point seat belt only,
• the lap belt part passes through both the blue guides placed on the car seat,
• the diagonal part of the belt passes round the back through the blue support
guide and the car seat, the vehicle seat belt is tight enough and not twisted
or rolled up.
• ENGLISH •
INSTALLING THE CAR SEAT
35