Service And Warranty - Dremel SCROLL STATION Instrucciones De Funcionamiento

This DREMEL product is guaranteed in accordance with statutory/country
specific regulations; damage due to normal wear and tear, overload or
improper handling will be excluded from the guarantee.
In case of a complaint, send the tool undismantled together with proof of
purchase to your dealer.
CONTACT DREMEL
For more information on the Dremel assortment, support or any ques-
tions, go to www.dremel.com.
Dremel Europe, P.O. Box 3267, NL - 4800 DG Breda
Always disconnect plug from the power source before making any adjustments or changing any accessory.
WARNING
!
TROUBLE
Breaking blades.
Jammed disc sander
Motor will not run.
Vibration
NOTE: There will always be some vibration present
when the saw is running because of motor operation.
GB

SERVICE AND WARRANTY

We declare under our sole responsibility that this product is in conformity with the following
standards or standardized documents: EN 61 029, EN 1050, EN 294, EN 55 014, in accor-
dance with the provisions of the directives 73/23/EC, 89/336/EC, 98/37/EC, 2002/96/EC.
The noise level when working can exceed 85 dB(A); wear ear protection. Measured in accor-
dance with EN 61 029 the sound pressure level of this tool is 78 dB(A) and the sound power
level 89 dB(A) (standard deviation: 3dB)
TROUBLESHOOTING
PROBLEM
1. Wrong tension.
2. Over working blade.
3. Wrong blade application.
4. Twisting blade in wood.
5. Incorrect teeth per inch.
1. Material jammed in disc.
1. Defective cord or plug
2. Defective motor.
3. Defective wire connections.
4. Brushes worn.
1. Unsuitable mounting surface.
2. Loose table or table resting against motor. 2.
12
CE DECLARATION OF CONFORMITY
REMEDY
1. Adjust blade tension, see REMOVING AND
INSTALLING BLADES .
2. Reduce feed rate, see BASIC SCROLL
SAW OPERATIONS .
3. Use narrow blades for cutting thin wood,
wide blades for thicker wood.
4. Avoid side pressure on blade - avoid over-
tensioning pin-end blade.
5. Blade should have minimum 3 teeth in con-
tact with workpiece.
1. Turn off and unplug saw. Remove material.
1. Replace defective parts before using saw
again.
2. & 3.Consult Dremel Service. Any attempt to
repair this motor may create a HAZARD
unless repair is done by a qualified service
technician.
4. Replace both brushes.
1. The heavier your work bench is, the less
vibration will occur. A plywood workbench
will not be as good a work surface as the
same size solid lumber. Use common
sense in choosing a mounting surface.
Tighten table wing knob.