Dremel SCROLL STATION Instrucciones De Funcionamiento página 8

DISPOSAL
The machine, accessories and packaging should be sorted for
environmental-friendly recycling.
GENERAL SPECIFICATIONS
Voltage Rating
Rated Power Input
No Load Speed
Throat depth
Blade length
Blade Stroke
Model number
Weight
UNPACKING
Always disconnect plug from the power source before
WARNING
!
making any adjustments, changing any accessory
when tool is not in use.
The scroll saw is shipped complete in one package.
◆
Separate all "loose parts" from packing materials and check each
item with the PACKING LIST to make sure all items are accounted
for before discarding any packing material.
If any parts are missing, do not attempt to operate
WARNING
!
scroll saw, plug in the power cord or turn the switch
on until the missing parts are obtained and are installed correctly.
◆
To remove protective coating from the table surface, moisten a soft
cloth with kerosene or WD-40 and wipe off coating. Do not use
acetone, gasoline or lacquer thinner for this purpose.
◆
After removing protective coating, you may apply a coat of paste
wax to the table to allow the workpiece to slide easily across the
table surface and deter rust. Wipe the table thoroughly with a
clean dry cloth.
PACKING LIST
Refer to figure 4
Item Description ................................................................................Qty
A 18" scroll station ..........................................................................1
B Owner's manual ..........................................................................1
C Side Table with side miter ............................................................1
D Screws ........................................................................................2
E Wing knobs ..................................................................................2
F Flip-up guard................................................................................1
230-240 V, 50-60 Hz
110 W
no 500-1500/min
470 mm
127mm
19mm
1800
24 kg
GB
ENVIRONMENT
ONLY FOR EC COUNTRIES
Do not dispose of power tools into household waste! According
the European Guideline 2002/96/EC for Waste Electrical and
Electronic Equipment and its implementation into national right,
power tools that are no longer usable must be collected separately and
disposed of in an environmentally correct manner.
SPECIFICATIONS
Always check that the supply voltage is the same as the voltage indicat-
ed on the nameplate of the tool (tools with a rating of 230V or 240V can
also be connected to a 220V supply).
ASSEMBLY
G Rear guard ..................................................................................1
H Disc wheel with abrasive disc......................................................1
Allen Wrench (2 mm, 2.5 mm & 4 mm) ......................................1
Drive Screw for sander ................................................................1
Adaptor for future additions ........................................................1
Spacer..........................................................................................2
O Ring..........................................................................................2
Drive Nut for Flex Shaft Attachment ..........................................1
Blades ..........................................................................................5
Hardware to mount this scroll saw to a bench or leg set is
NOTE
NOT supplied.
INSTALLING THE DISC SANDER
Refer to figure 5
◆
Assemble the rear guard of the disc sander to the scroll saw using the
two screws.
◆
Insert the disc wheel with the abrasive disc.
◆
Insert the disc screw and tighten the abrasive disc to the motor.
INSTALLING THE SIDE TABLE & GUARD
Refer to figure 6
◆
Assemble the side table and guard, using two wing knobs, large
spacers, screws, and o-rings.
◆
Put spacers on wing knobs, then insert through sliding scales on
sides of table and screw into bottom holes in base.
◆
Insert fthe screws through clear plastic guard, then though o-rings
and tighten into top holes on table and base.
◆
Adjust table to desired angle and tighten wing knobs.
8
MOTOR SPECIFICATION