Starting / Stopping The Engine - Stihl HS 87 Manual De Instrucciones

English
Turn the cap (with the grip up) until
N
it drops into the fuel tank opening.
Next, turn the cap counter-
N
clockwise as far as it will go
(approximately 1/4 turn). This will
rotate the base of the cap into the
correct starting position for
installation. The exterior positioning
mark (1) on the cap will line up with
the "unlocked" symbol (2) on the
fuel tank housing.
Then, turn the cap clockwise,
N
closing it normally.
If your fuel cap still does not tighten
N
properly, it may be damaged or
broken. Stop using the unit and take
it to your authorized STIHL dealer
for repair.
16
Starting / Stopping the
Engine
1
Observe safety precautions – see
N
chapter on "Safety Precautions and
Working Techniques".
2
1
The slide control (1) is in the normal run
position F.
Press the manual fuel pump bulb at
N
least five times – even if the bulb is
filled with fuel.
Cold engine (cold start)
2
Depress the outer ring (arrows) of
N
the choke knob (2) and then turn it
to g .
Warm engine (warm start)
2
Depress the outer ring (arrows) of
N
the choke knob (2) and then turn it
to f.
Also use this setting if the engine has
been running but is still cold.
HS 87 R, HS 87 T