Stihl TS 440 Manual De Instrucciones página 41

4
Set the choke (4) according to the
N
engine temperature
c If engine is cold;
e if the engine is warm or
if a warm engine has been shut off
for less than 5 min;
f if the engine is hot or
if a hot engine has been shut off for
longer than 5 min;
Press the bulb (6) of the manual fuel
N
pump 7 - 10 times
even when the
bulb is still filled with fuel
TS 440
Starting
Place the cut-off machine carefully
N
on the ground or other solid surface,
ensuring that the abrasive cutting
wheel does not touch the ground or
any objects. There must not be
anyone within the swivel range of
the cut-off machine. Never attempt
to start the cut-off machine when the
abrasive cutting wheel is in a cut
Make sure you have a secure
N
footing
Press the cut-off machine firmly
N
against the ground or other solid
surface, holding the handle with
your left hand, thumb wrapped
round the handle
Press the cut-off machine against
N
the ground or other solid surface
with your right knee on the rear
handle or body of the cut-off
machine
6
Pull the starter grip slowly with your
N
right hand until you feel it engage
then give it a brisk strong pull
not pull the starter rope all the way
out
WARNING
Do not let the starter grip snap back
may break or you may injure your hand
or fingers. Guide it back into the housing
in the opposite direction so that it can
rewind properly.
WARNING
Do not drop start the cut-off machine.
Drop starting means pushing the
machine away from the operator, or
allowing it to drop toward the ground,
while pulling on the starter grip. This
method is very dangerous because you
could lose control of the cut-off machine.
When the engine has turned over for the
first time
Set the choke lever (4) to f
N
Continue cranking
N
do
English
it
4
39