Operation And Internal Display - Nikon Laser 550A S Manual De Instrucciones

External display
Measure the distance between two points
Jp
En
[Results]
Fr
After measuring two points, "Linear
distance to two points" and "Vertical
Es
separation (height) and angle
Pt
between two points" are displayed.
Units can be shown in meters or
yards. Angles are indicated by
°(degree).
Linear distance (1st point)
Linear distance (2nd point)
Vertical separation (height between two points)
Angle of two points
Unit
[Measuring 1st point] [Failed to measure 1st point]
Angle measurements never fail.
[Results of 1st point]
48
Measuring 2nd point
[ ] [Failure to measure 2nd point]
Although the point is located
Angle measurements never fail.
downward, display shows the
upward position.
[Display of results for vertical separation (height between two
points) and 2nd point]
Vertical separation After displaying vertical
(height between two points) separation (height between
two points), pressing MODE
button displays the result of
the 2nd point.

Operation and internal display

【0 • 1 • 2】 Power On/Off and others
Operation/Results Work
0 Switch for FULL/Limited Perform this operation
modes when power is off.
Operation is complete (1) Initial screen
When switching to Limited mode
When the symbol (shown on right)
does not appear, Limited mode is switched
to Full mode.
After approx. two seconds, proceed to (2).
(2) Measurement standby
1 Power On Initial screen
Measurement standby When this symbol (shown on right)
does not appear, Limited mode is set.
Measurement standby
2 Selecting and setting (1) Linear distance【3】
Limited mode
(2) Horizontal distance【4】
(3) Height (from horizontal)【5】
The angles and heights
between two points are
(4) Angle (from horizontal)【6】
displayed only at the FULL
mode setting.
(5) Vertical separation
Linear distance, Horizontal
(height between two points)【7】
distance and height are
displayed when FULL/
Return to 2-(1) Linear distance,
Limited mode is set.
then repeat.
See the relevant section in this manual for each mode setting and display.
Regardless of process, after 30 seconds
8
Power off
since your last operation, power turns off.
Button Display Display examples
MODE
+(follow by) POWER
Initial screen (FULL mode)
Last use symbol
All symbols
POWER
(while pressing)
Last Use mode symbol
n/a
MODE n/a
MODE n/a
MODE n/a
MODE n/a
blinks.
n/a
30 seconds
without operation
Jp
En
Fr
Es
Pt
49