6-position switch settings
Upper heat
Upper and lower heat
Upper heat with hot-air convection
Upper and lower heat with hot-air
convection
Upper heat with rotating spit
Upper heat with hot-air convection and
rotating spit
The heating elements will only be switched
on after the timer is activated.
Timer
∙ The timer can be used for selecting a
cooking time (up to 120 minutes).
∙ To turn the appliance off, turn the timer
knob to position OFF.
∙ To programme a time, turn the timer
knob clockwise to the desired value.
∙ To set a time of less than 20 minutes,
turn the timer to a somewhat higher
setting first and then slowly turn it back
to the desired time setting. After the
pre-programmed time has elapsed, an
acoustic signal indicates that the heating
elements are switched off.
Indicator lamp
The indicator lamp lights up when the
appliance is switched on. It goes out once
the pre-programmed time has elapsed, or if
the switch is turned back to position OFF.
14
Rotating spit
∙ When the food to be cooked is put onto
the spit, make sure that it does not come
into contact with the upper or lower
heating elements; ensure sufficient
distance.
∙ Pierce the food to be cooked on the spit,
making sure that the spit goes through
the middle. This is to ensure that the
food does not go to near the interior
walls or the heating elements. Use the
holding clamps to secure the food in the
centre of the spit.
∙ Any parts sticking out (e.g. wings of a
chicken) should be held in with a tooth-
pick, a piece of string or other suitable
means. This ensures that no part of the
food can protrude or come off during the
cooking process.
∙ Inserting and removing the rotating spit:
∙ Once the food has been securely
attached, place the spit onto the
handle assembly. Ensure that the spit
is safely supported in the recesses in
the handle.
∙ Slide the spit end-piece with the drive
unit connection into the drive unit (see
picture II).
∙ Place the idle end of the spit into its
holding bracket on the opposite side
(see picture I).
∙ To remove the rotating spit, follow
these steps in reverse order.