OcCre Palamós Instrucciones De Montaje página 7

PHOTO 100. Glue the baseboards (nos. 121, 122, 123, 124, 125 and 126) into place on the base of the cabin, respecting the
projections that stick out from the base.
PHOTOS 101 / 102. Glue the finials (no. 127) to the outer corners of the cabin. Also glue into place the parts (nos. 128, 129,
130, 131, 132, 133 and 134).
PHOTO 103. Cut to size the windows (no. 135) and glue them inside the cabin. Attach the parts A and L to the doors.
PHOTOS 104 / 105 / 106. Line the roofs (nos. 136 and 137) using the lining (no. 138). Then fit the finials (no. 139).
PHOTO 107. Insert and glue the riveting (no. 140) into place. Use the handle of a tool as a guide, then make up the part (no.
141). Also make up the part (no. 142). Now glue the parts (nos. 141 and 142) in the riveting (no. 140).
PHOTO 108. Glue the roofs to the cabin. Paint the running lights (no. 143) and the top of the funnel (no. 144) and glue them into
place. Using an eyebolt B and the thread (no. 146) make up the bell (no. 145) and glue it as shown in the image.
PHOTOS 109 / 110 / 111. Make up the parts (nos. 147 and 148). Glue the parts (nos. 149 and 150) and paint them white. Paint
the lifebuoy (no. 85). Then glue the parts (nos. 85, 147, 148, 149 and 150) in the cabin and glue the cabin to the deck, as shown
in the image.
PHOTO 112. Roll up a length of thread (no. 151) and glue it to the deck of the boat.
PHOTOS 113 / 114. Glue the parts (nos. 152, 153 and 154, to make up the base. Then sand it down and stain it the colour of
oak or walnut.
MASTS AND RIGGING
In order to make up the masts the first step is to cut the rods to size, as indicated in the parts list, or by taking measurements
directly from the plan, which is printed in 1/1 scale.
All of the masts have a certain conical shape to them.
PHOTO A. In order to achieve this conical shape for the masts, sand down the rod (using a sander), sanding down more as you
get closer to the end where you want to decrease the diameter. Roll the rod so that the wear is the same all round it.
PHOTO B. Repeat the above operation until the diameter is as indicated in the plan. Note the difference between a treated rod
and another that has not been worked on.
In order to make up the masks for this model correctly you must take the following into account:
- The Plan
- The close up photos of the masts
- The measurements and description of the materials given in the parts list
- The "IP" or Parts Identification sheets
The masts must be varnished and some of the parts that make them up will have to be painted.
Once the masts have been assembled and varnished attach their tackle (slings, blocks, eyebolts, clump blocks, etc.) and attach
them to the boat. The masts must be inserted until they come up against the slots of in the false keel.
RUNNING GEAR
In order to make up the running gear for this boat follow the numeric order printed together with the instructions, indicating the
order for fitting (ropes, clump blocks, blocks, etc.).