Extension Cord; Tool Settings; Electronic Control; Pendulum Stroke - Festool TRION PS 300 EQ Manual De Instrucciones

3.1
PS 3 0 0 EQ
4.1
Press the pushbutton switch again to release the
lock.
If an extension power cord is required, it must have
suffi cient cross-section to prevent an excessive
drop in voltage or overheating. An excessive drop in
voltage reduces the output and can lead to failure
of the motor. The table below shows you the correct
cord diameter as a function of the cord length for
the PS/PSB 300 EQ.
Total Extension Cord
Lenght (feet)
Cord size (AWG)
Use only U.L. and CSA listed extension cords. Never
use two extension cords together. Instead, use one
longer one.
Note: The lower the A.W.G. number, the thicker
the cord.
power supply before making any adjustments to the
tool or installing or removing any accessory!
3.2
The PS 300 EQ and PSB 300 EQ have control elec-
tronics which enable stepless adjustment of the
stroke rate between 1000 and 2900 strokes per
minute. The desired stroke rate is set with the speed
controller [3.1, 3.2]:
Recommended stroke rate (speed controller set-
PS 3 0 0 EQ
ting):
Hard and soft wood, wood core plywood:
Plywood, chip board:
Wood fi berboard:
Plastics:
Ceramic:
Aluminum, NF metals:
Steel:
In order to cut different materials with an optimum
feed movement, these pendulum jigsaws have an
adjustable pendulum stroke. Select the desired
setting with the pendulum stroke switch [4.1]:
Setting 0 = pendulum stroke off
Setting 3 = maximum pendulum stroke
6

Extension cord

25
18

Tool settings

Always disconnect the plug from the

Electronic control

Pendulum stroke

50 100 150
16 12 10
6
6
4-6
3-6
3-5
3-5
2-4