Changing Channels - Pioneer PDP-505HDG Manual De Instrucciones

07 Watching TV
Plasma Display/Media Receiver status indicators
Plasma Display
POWER ON STANDBY
Flashing
For other than the above, see "Troubleshooting" on page 63.
CHANNEL +/–
24
En
Indicator Status
Media Receiver
POWER ON STANDBY
Flashing
Plasma Display
(right view)
CH
ENTER
Channel display
8
AAA
STEREO
STANDARD
FULL
System Status
Power to the Plasma Display and Media Receiver is off. Or the power
cords have been disconnected.
Power to the system is on.
The system is in the standby mode.
Power to the Media Receiver is off. Or the power cord has been discon-
nected from the Media Receiver.
Power to the Plasma Display is off. Or the power cord has been discon-
nected from the Plasma Display.

Changing channels

Using P +/– on the remote control unit
• Press P + to increase the channel number.
• Press P – to decrease the channel number.
When viewing Teletext information:
• Press P + to increase the page number.
• Press P – to decrease the page number.
• CHANNEL +/– on the Plasma Display operates the
same as P +/–.
Using 0 – 9 on the remote control unit
Select channels directly by pressing buttons 0 to 9.
EXAMPLE
• To select channel 2 (1-digit channel), press 2.
• To select channel 12 (2-digit channel), press 1 then 2.
When viewing Teletext information:
View a page directly which is 3-digit page number from
100 to 899 by pressing buttons 0 to 9.
• After entering a channel or subchannel number, you
may press CH ENTER to tune in the channel more
quickly.
• In the standby mode, when you press 0, the power
turns on and the on-screen image comes from the
INPUT 1 source. Or, when you press any button from
1 to 9, a TV image displays.