Stem Assembly (Top Part) - Look 796 Monoblade RS Manual De Uso

EN
GENERAL TOLERANCES :
Dimension from 0 to 15 : ±0.15
Dimension from 15 to 30 : ±0.20
Beyond : ±0.25
Angles : ±30'
Surfaces finish : 80 grit sand blast
Free of positive metal, voids and porosity
Free of cutting oil and oil residue
Fig. 11
When the bike routing is finalised you can then finish fitting the top part of the stem②
1- Position the stem cap②
Volume (mm3)
2- Pre-tighten the 8 screws②
of and one behind the stem, diagonally opposite.
3- Tighten the 8 screws cross-wise to 8 Nm torque.
All information contained on this drawing is property of LOOK CYCLE INTERNATIONAL. Its reproduction for any use in any way or for commercial
purpose is forbidden. All rights on this material are reserved.
Note : The screws②
them. On the contrary, after several fittings/refittings it will be necessary to redeposit a drop
of normal thread lock(Loctite blue 243 type).
19

Stem assembly (top part)

Nature de la modification
2
taking care not to pinch any electric cable or brake cable.
ECHELLE 2:5
Masse (g)
4
using a 4 mm ball end Allen key. Start with on screw in front
FORMAT A4
Dessiné par Date
Vérifié par Date
4
are preimpregnated with threadlock. It is essential not to grease
Resp
Matière
ENSEMBLE
DESIGNATION
2
.
Date Ind.
Traitement
REFERENCE PROTO.
REFERENCE