Program A Unit Equipped With A Modem; Set Up The Wireless Account - Hach FL900 Serie Manual Del Usario

Ocultar thumbs Ver también para FL900 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 105
Figure 8 User interface
1 Instrument without modem
Indicator

Program a unit equipped with a modem

Electromagnetic radiation hazard. Make sure that the antenna is kept at a minimum distance of 20 cm
(7.9 in.) from all personnel in normal use. The antenna cannot be co-located or operated in conjunction
with any other antenna or transmitters.
For units without a modem, refer to
2
modem accounts
, go to

Set up the wireless account

Note: Adequate cellular coverage from the selected carrier must be verified for each site before a logger with a
cellular modem is purchased.
Network and access point security is the sole responsibility of the customer using the wireless instrument. The
manufacturer will not be liable for any indirect, special, incidental or consequential damages caused by a breach
in network security.
When the logger has a modem, data can be sent from the logger to the internet for remote access.
The user must first open an account with a mobile (wireless) provider. The instrument is then
registered to the data-hosting server (FSDATA), and the applicable communication settings are
programmed into the logger with FSDATA Desktop. If the modem was activated at the factory, go to
Add the logger to the FSDATA Server
Pre-requisite: Make sure that the logger, logger test certificate and antenna are nearby.
2
The units that come with activated modem accounts have part numbers with .AX, .AR, .VX,
or .VR as the last digits.
Table 3 LED status indicators
LED color Description
Green
Flashes every 3 seconds during normal operation. Flashes every
15 seconds during sleep mode.
Red
Flashes when an attached sensor does not agree with the logger
program, an expected sensor is not found or the sensor operation has
failed.
Green
Stays green during a call to the server.
Red
Flashes red if the call to the server failed.
C A U T I O N
Basic setup
Add the logger to the FSDATA Server
N O T I C E
on page 18.
2 Instrument with modem
on page 21. For units that come with activated
on page 18.
English 15

Publicidad

Tabla de contenido
loading

Tabla de contenido