Cleaning And Maintenance; Defrosting; Cleaning; Lamp And Change Method - Haier HRF-800DGS8 Manual Del Usuario

6. Cleaning and Maintenance

Defrosting

Defrosting is done automatically so there is no need to
manually defrost this appliance.
DO NOT use mechanical devices to accelerate the
defrosting process.

Cleaning

Clean the appliance when only little or no food is stored.
The appliance should be cleaned every four weeks for good
maintenance and to prevent bad stored food odors.
Disconnect the appliance from the power supply before
cleaning.
DO NOT use harsh abrasives, or aggressive cleaners as
these can damage the interior of the appliance.
The appliance is heavy. When moving the appliance be
careful to protect the floor.Keep the appliance vertical
and do not tilt the appliance – this prevents damage to
the floor.
DO NOT spray or rinse the fridge with water or other
liquids. This could harm the electrical parts.
Use a dry cloth when cleaning near the electrical parts
(such as the light or switch).
DO NOT clean the fridge with a stiff or wire brush.
DO NOT use an organic solvent such as detergent,
petrol, lacquer, thinners, acetone or acid.
To prevent your skin sticking to cold steel parts, make
sure your hands are not wet when touching the parts.
DO NOT use HOT water to clean the glass shelves, as
they may break or crack.
A possible temperature rise during the cleaning can shorten the
storage time of frozen food. In case of heat the condition of
frozen goods must be checked.
Empty the appliance of food and remove the shelves.
Clean the interior using warm water and bicarbonate of soda
with a soft cloth. Make sure that the interior is then dried
carefully with a suitable cloth.
Shelves and other accessories (plastic and glass parts) can
be cleaned in the sink using liquid dishwashing liquid and
water.
Make sure all soap is rinsed off and all parts are dry before
replacing them inside the appliance.
Always keep the door seals clean.
Allow at least 5 minutes before restarting the appliance as
frequent starting may damage the compressor.
Remove The Bottle Holders (Fig. 6-1)
1. Hold both sides of the door bottle holder to lift it upward in
the direction of ① .
2. Pull out in the direction of ② .
Fig.6-1

Lamp and change method

Refrigerating chamber lamp
Refrigerating chamber lamps adopt LED light, this kind of
light has the features of lower energy consumption and long
lifetime.
If lighting is abnormal, please contact aftersales person for
onsite service, and do not change it by yourself
Lighting Parameters (Fig. 6-2):
Top Lamp: DC 12V / 2.5W
①
Backboard lamp: DC 12V / 6W
②
Internal lamp of My zone drawer: DC 12V / 0.25W
③
Bottom lamp of My zone drawer: DC 12V / 0.7W
④
1
Fig.6-2
2
3
4
19