Levelling The Appliance And Adjusting The Doors; Levelling The Doors By The Feet; Fine Tuning Of The Doors; Electrical Supply Connection - Haier HRF-800DGS8 Manual Del Usuario

Fig.5-8
Fig.5-10
Fig.5-11
spanner
Freezer door
Fig.5-12
descend
Hinge lifting
shaft
clockwise
Fig.5-9
Height
difference
Refrigerator
door
Fig.5-13
rise
Hinge lifting
shaft
counterclockwise
Levelling the Appliance and Adjusting the
Doors
Make sure that the appliance is on solid level flooring. If the
appliance is placed on a plinth, flat, strong and fire resistant
materials must be used.

Levelling the Doors by the Feet

The doors may require some alignment before connecting
the fridge-freezer to the electrical supply. This can be done by
adjusting the levelling feet (Fig.5-8 and Fig.5-9).
Insert a suitable flat screwdriver into the slots of the adjust-
able feet. Turn the screwdriver clockwise to raise the feet
(Fig.5-8), and counter-clockwise to lower the feet (Fig.5-9).
To raise the left-hand door turn the left-hand foot clockwise
until it is level (Fig.5-10).
To raise the right-hand door, turn the right-hand foot clockwise
until the it is level.

Fine Tuning of the Doors

If the doors are still not in one level after levelling the doors by
the feet (Fig. 5-11), this mismatch can be remedied by turning
the hinge lifting shaft at the right bottom corner of refrigerating
door with a spanner (enclosed in the accessories bag).
Clockwise turn lifting shaft with spanner to lower door height
(Fig. 5-12).
Antic lock wise turn lifting shaft with spanner to lift door height
(Fig. 5-13).
Please do not adjust the hinge lifting shaft excessively to
a height which might cause the shaft to leave its original
locked position. (Adjustable height range: 3 mm)

Electrical Supply Connection

Connect the appliance to the electrical supply (220-240 V ~
50Hz) with the plug and lead, which are fitted.
Connections to the mains supply should be in accordance
with local regulations.
The mains electricity supply must be conformed to the
rating plate as shown on the inner of the appliance part.
The appliance must be plugged into an earthed socket.
Always make sure that the plug is accessible after the
appliance has been positioned.
18