Delta 33-890 Manual De Instrucciones página 11

ATTACHING THE STARTER BOX TO THE BASE (33-891 AND 33-892 MODELS)
For machines with a magnetic starter, trans form er, and
overload protection, follow these instructions to attach
the starter box to the base:
1. Attach the bracket (A) to the bottom of the right side
of the saw base (Fig. 13). Place a 1/4" flat washer
on a 1/4-20 x 3/4" hex head screw. Insert the screw
through the hole in the bottom of the right side of the
saw base. Place the bracket (A) Fig. 13 on the screw.
Place a 1/4" lock washer on the screw. Thread a 1/4-
20 hex nut on screw. Tighten securely.
2. Attach the starter box (B) Fig. 14 to the right side
of the base. Place a 1/4" lockwasher on a 1/4-20 x
1/2" hex head screw. Place a 1/4" flat washer on the
screw. Insert the hex head screw (C) through the hole
in the in the bracket (E). Thread the screw into the
weld nut (D) Fig. 14 in the back of the starter box (B).
Repeat this process for the two remaining holes in
the base (G) and the holes (F) in the starter box.
ADJUSTING THE TABLE BRACKETS PARALLEL TO THE TRACK ARM
To perform accurate work, be sure that the track arm is parallel to the table top brackets at both the front and rear of
the machine. To check the alignment:
1. Loosen the yoke clamp locking lever (A) Fig. 15. Pull up the yoke clamp index knob (B) and rotate the yoke (C)
Fig. 16 to the out-rip position. Tighten the yoke clamp locking lever (A) Fig. 15.
A
2. Use the open-end wrench (D) Fig. 17 on the flats
of the arbor and loosen the arbor nut (E) with the other
wrench (F).
B
C
Fig. 15
C
B
A
11
A
Fig. 13
G
F
B
E
D
Fig. 14
Fig. 16
D
E
F
Fig. 17
C