Loading The Fastening Tool With Nails; Using The Support Leg - Hilti BX 3-ME Manual De Instrucciones

5.7

Loading the fastening tool with nails

5.7.1 Loading for magazine operation
WARNING
Risk of crushing! Allowing the nail pusher to snap back under spring pressure may result in finger injuries
and cause damage to the fastening tool.
▶ When pulling the nail pusher down, take care to ensure that it engages securely. Do not allow the nail
pusher to jump back under spring pressure.
1. Pull the nail pusher down until it engages.
2. Slide the nail strip(s) into the magazine (a maximum of 2 strips of 10 nails per strip).
3. Hold the nail pusher securely and press the nail pusher release mechanism.
4. Guide the nail pusher back.
5.7.2 Loading for single-fastener mode
CAUTION
Crush hazard! If it is allowed to snap back, the nail pusher can cause injuries and damage the fastening tool.
▶ When you pull down the nail pusher make sure it engages securely. Do not allow the nail pusher to snap
back.
1. Pull the nail pusher down until it engages.
2. Slide the nail strip(s) out of the magazine and check that the magazine is empty.
Damage to the fastening tool can result if you do not remove all the nails from the magazine before
using the tool in single-fastener mode.
3. Hold the nail pusher securely and press the nail pusher release mechanism.
4. Guide the nail pusher back.
5. Insert the nail into the recess in the fastener guide. Optionally, you can then also fit an approved fastening
element on to the nose of the fastener guide.
Attempting to drive a fastener with more than one nail in the fastener guide can cause damage
to the fastening tool. When operating the tool in single-fastener mode, load only one nail into the
fastener guide.
6. Activate the single-fastener selector switch.
◁ The single-fastener switch engages with an audible click.
Pulling the nail pusher down a few centimeters will disengage the single-fastener switch.
6 Operation
6.1

Using the support leg

On an even working surface, the support leg makes it easier to hold the fastening tool perpendicular as
attention then only has to be paid to lateral alignment. On uneven surfaces it might be necessary to retract
the support leg in order to ensure that the fastener guide is perpendicular to the working surface.
6.1.1 Retracting the support leg
CAUTION
Risk of pinching the fingers! When folding the support leg back there is a risk of trapping and pinching the
fingers between the support leg and the casing of the tool.
▶ Hold the fastening tool by the grip when extending/retracting the support leg.
1. Push against the support leg to release it from its engaged position.
2. Pivot the support leg back through about 180°.
3. Push against the support leg from below until it engages in the retracted position.
24 English
Printed: 19.07.2018 | Doc-Nr: PUB / 5377483 / 000 / 02
4
5
6
2184328
*2184328*