Final Assembly (Qualified Specialist) - Speck BADUJET Primavera Instrucciones Para El Manejo

Installation
5.3

Final assembly (Qualified specialist)

WARNING
Injury due to suction if the suction panel is not mounted!
 It is imperative that the suction panel is mounted.
All guarantee rights and claims for compensation are rendered
invalid for damage resulting from the suction panel not being
mounted or being mounting incorrectly.
NOTICE
Only tighten the screws hand-tight. Do not use any force!
After the installation of the main housing (pre-assembly kit):
1. Bond the cable protective conduit and the outer air hose.
(Fig. 15)
2. Insert the O-ring (108) in the main housing (1). (Fig. 16)
3. Screw the ten enclosed tapping screws (61) into the nozzle
housing. Place the pre-assembled nozzle housing (102.1)
onto the main housing (1). (Fig. 16)
4. Lead the pneumatic hoses (47) and floodlight cables through
the protective conduit (14) and seal with the cable gland (20).
(Fig. 16)
5. Fasten the internal air line (4), which is already completely
pre-assembled at the nozzle housing (102.1) or air regulator,
to the main housing (1) with the hose clamp (9). (Fig. 16)
6. Lead the pneumatic hoses through the lower or outer
openings of the nozzle housing (102.1); light ON/OFF left;
pump ON/OFF right. (Fig. 16)
7. Align the complete nozzle housing (102.1) to the main
housing (1) and fasten the ten pre-assembled tapping screws
(61). (Fig. 16)
8. Place the suction panel (93) on the support ring (28) and
fasten with four plain washers (94) and four tapping screws
(95). (Fig. 17)
 Take the mounting position into account.
9. Align the stainless steel cover with the protruding centring
nubs to the existing recesses of the suction panel (93) and
press them together by hand. Observe the "UP" marking on
the stainless-steel cover. To fasten the cover use a
30 EN 01|2018