Adjusting The Headlight - Beta RR 50 CC Serie Manual Del Usuario

3
ADJUSTING THE
HEADLIGHT
A
The beam is adjusted by loosening the left
and right fixing screws A of the mask and
manually changing the inclination of the
mask's complete optical unit by sliding the
fixing screws into the support slots.
Periodically check the direction of the
beam. The beam can only be adjusted
vertically.
Place the vehicle on level ground (but not
on the stand) 10 metres from a vertical
wall.
Measure the height of the headlight centre
above the ground and then draw a cross
on the wall at 9/10 of the height of the
headlight centre.
9
x
x
10
Turn on the low beam, get on the motorbike
10 m
and check that the headlight beam on the
wall is slightly lower than the cross drawn
previously.
EN
39