3M Speedglas Adflo Instrucciones De Uso página 8

MAINTENANCE
Carefully inspect the equipment frequently and replace worn or damaged
parts. Only use "3M Approved" manufacturer's original parts according to
parts list.
WHAT
General Inspection
Cleaning
Protective fi lm replacement: See fi g D:1
Face seal replacement: See fi g E:1.
If disposal of parts is required this should be undertaken in accordance
with local environmental health and safety regulations.
If you suspect that the inside of the airduct/breathing tube is dirty it must be
replaced with a clean one.
Cleaning
To avoid damage to the product, do not use solvents for cleaning. Clean
the Visor with a mild detergent and lukewarm water.
Storage
The equipment must be stored in a dry clean area away from direct sunlight,
in the temperature range of –30°C to +70°C and relative humidity less than
90%.
The original packaging for this Visor is suitable for further transportation of
the product.
WHEN
Before use
Monthly if not in regular use
After use
1ï
5