Waeco MagicSpeed MS900 Instrucciones De Montaje página 23

_MS-901.book Seite 23 Montag, 3. September 2007 4:33 16
MagicSpeed
6.2 Fitting the electronic module
Note
I
When selecting the installation location, observe the following in-
structions:
Install the electronic module
– Near the CAN-Bus plug
– Not anywhere subject to heat or moisture
– Not in the engine compartment
– Not near high-voltage components
– Not directly next to ventilator nozzles
Where possible, use existing holes in the vehicle.
Caution
a
Before drilling holes, make sure the bit will not damage anything on
the other side (fig. 2, page 3).
➤ Select a suitable installation location (fig. 5, page 4).
Note
I
The electronic module can be attached to the vehicle using the
screws supplied or double-sided adhesive tape.
➤ Temporarily mount the electronic module at the selected position.
Do not fasten the electronic module before you have decided where to
lay the cables.
➤ After finishing the electric wiring, fasten the module in the selected posi-
tion:
– Fasten the electronic module using double-sided tape or ...
– Mark the holes for installation.
– Drill two holes with 3 mm diameters.
– Tightly fasten the electronic module using the screws provided.
MagicSpeed installation
23