HumanTechnik lisa combi II RF Instrucciones De Servicio página 9

Accessory: telephone
cable.
Accessory: Microphone cable with
2.5 mm jack plug
Congratulations on purchasing your
combi II RF. We hope it will give you
many years of reassuring operation.
Please read through these operating
instructions carefully. They tell you
how to set up the system correctly
and explain all the system's features
to you.
Operating principle
A signalling system consists of at
least one transmitter and one recei-
ver. The combi II RF picks up the rin-
ging signals from telephone and
doorbell through an electrical
connection. It converts these signals
into radio pulses (868.35 MHz) and
transmits them to the receiver with-
out the need for wires.
Special features
When a signal is detected, it is
transmitted for a total of 22
seconds. This increases both the
reliability and the range of the
system.
Included in the standard
package:
- combi II RF
- Telephone cable, length 1 m
- Microphone cable, length 1 m
- Stand
- 9 V block battery
- Operating Instructions
- Warranty card
If any parts are missing please
immediately contact your dealer or
the manufacturer directly.
Setting up the system –
1. Inserting the battery
There is a battery compartment on
the back of the combi II RF. Open it
by sliding the cover of the battery
compartment to the right of the
receiver using your thumb. Connect a
9 V block battery to the connector
plug, place the battery into the
recess and close the receiver again.
When the battery is connected, the
receiving signals may be triggered
once.
English 9