Power Management; Product Specifications; Features - Power Stroke PSi2000 Serie Manual Del Operador

POWER MANAGEMENT

To prolong the life of the generator and attached devices,
it is important to take care when adding electrical loads to
the generator. There should be nothing connected to the
generator outlets before starting its engine. The correct and
safe way to manage generator power is to sequentially add
loads as follows:
1. With nothing connected to the generator, start the engine
as described later in this manual.
2. Plug in and turn on the first load, preferably the largest
load you have.
3. Permit the generator output to stabilize (engine runs
smoothly and attached device operates properly).
4. Plug in and turn on the next load.
5. Again, permit the generator to stabilize.
6. Repeat steps 4 and 5 for each additional load.
Never add more loads than the generator capacity. Take
special care to consider surge loads in generator capacity
as previously described.
NOTICE:
Do not overload the generator's capacity. Exceeding the
generator's wattage/amperage capacity can damage the
generator and/or electrical devices connected to it.

PRODUCT SPECIFICATIONS

ENGINE
Engine Type ......................... Single Overhead Cam (SOHC)
Spark Plug ..........................................................LD A7RTC
Cooling System ...................................................Forced Air
Starting System ......................................................... Recoil
ELECTRICAL
Application/Equipment
Emergency / Home Standby
Lights (qty. 4 x 75 W)
Refrigerator
46 in. Flat Panel Television
Satelite Receiver
Portable Fan
Heater
Laptop
Slow Cooker
Radio
Job Site
Electric Drill − 3/8 in.
Quartz Halogen Work Light
Reciprocating Saw
Circular Saw − 7-1/4 in.
Miter Saw − 10 in.
Air Compressor − 1/4 HP
Airless Sprayer − 1/3 HP
*Wattages listed are approximate. Check tool or appliance for actual wattage.

FEATURES

GENERATOR
Rated Voltage .........................................120 V AC/12 V DC
Rated Amps ............................................14.2A AC/7.5A DC
Rated Running Watts ............................................. 1,700 W
Starting Watts ......................................................... 2,100 W
Rated Frequency ........................................................ 60 Hz
Page 9 — English
Estimated*
Estimated
Additional
Starting
Starting
Watts*
Watts
300 300
700 1350
190 190
250 250
40 120
1300 1300
250 250
270 270
50 50
600 1000
1000 1000
960 1920
1400 2300
1800 1800
970 1600
600 1200